Hostname: page-component-8448b6f56d-xtgtn Total loading time: 0 Render date: 2024-04-20T01:25:53.940Z Has data issue: false hasContentIssue false
  • English
  • Français

Correlation between Barkhausen noise and mechanical sensitivity in FINEMET-type materials

Published online by Cambridge University Press:  31 January 2011

G. Eszenyi ,
S. Szabó ,
L. Harasztosi ,
F. Zámborszky ,
J. Nyéki ,
Z. Erdélyi  and
D.L. Beke
G. Eszenyi
Affiliation:
Department of Solid State Physics, University of Debrecen, 4010 Debrecen, Hungary
S. Szabó
Affiliation:
Department of Mechanical Engineering, University of Debrecen, 4028 Debrecen, Ótemető 2–4, Hungary
L. Harasztosi
Affiliation:
Department of Solid State Physics, University of Debrecen, 4010 Debrecen, Hungary
F. Zámborszky
Affiliation:
Magnetec Ungarn GmbH, H-3200, Gyöngyös, Pipis hegy, Hungary
J. Nyéki
Affiliation:
Magnetec Ungarn GmbH, H-3200, Gyöngyös, Pipis hegy, Hungary
Z. Erdélyi
Affiliation:
Department of Solid State Physics, University of Debrecen, 4010 Debrecen, Hungary
D.L. Beke*
Affiliation:
Department of Solid State Physics, University of Debrecen, 4010 Debrecen, Hungary
*
a) Address all correspondence to this author. e-mail: dbeke@delfin.unideb.hu.
Get access

Abstract

FINEMET-type (Fe75Si15NbBCu) ribbons were heat treated, and their magnetic properties were analyzed. Permeability, thermal, and mechanical sensitivities were measured by commonly used industrial methods, and these properties were correlated with measured magnetic Barkhausen noise parameters. Distributions of peak area, A, and peak noise energy, E, were evaluated. Distribution functions of noise parameters, P(x), were in good agreement with the theory of self-organized criticality (SOC), satisfying power laws in the form P(x)∼x−α. It is found that the noise did not considerably depend on the temperature sensitivity parameter and on the permeability of ribbons. However, a useful correlation between the noise parameters and mechanical sensitivity has been observed. Minimal noise was detected for samples with negligible mechanical sensitivity in an amorphous-nanocrystalline composite state obtained by a heat treatment at 853 K.

Keywords

AmorphousMagnetic propertiesNanostructure
Type
Articles
Information
Journal of Materials Research , Volume 24 , Issue 1 , January 2009 , pp. 130 - 134
Copyright
Copyright © Materials Research Society 2009

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1.Balogh, Z., Daróczi, L., Erdélyi, Z., Szabó, S., Juhász, R., Beke, D.L.: Barkhausen noise measurements in amorphous and nanocrystalline FINEMET type alloys. Mater. Sci. Forum 537-538, 291 2007CrossRefGoogle Scholar
2.Bertotti, G., Mayergoyz, I.: The Science of Hysteresis Vol. II, 1st ed.Elsevier Inc. Amsterdam, The Netherlands 2006 107267Google Scholar
3.Durin, G., Zapperi, S.: Scaling for Barkhausen avalanches in polycrystalline and amorphous ferromagnets. Phys. Rev. Lett. 84, 204705 2000CrossRefGoogle ScholarPubMed
4.Durin, G., Zapperi, S.: Barkhausen noise in soft amorphous magnetic materials under applied stress. J. Appl. Phys. 85, 85196 1999CrossRefGoogle Scholar
5.Santi, L., Bohn, F., Viegas, A.D.C., Durin, G., Magni, A., Bonin, R., Zapperi, S., Sommer, R.L.: Effect of thickness of statistical properties of the Barkhausen noise in amorphous films. Physica B 384, 144 2006CrossRefGoogle Scholar
6.Spasojevic, D., Bukvic, S., Milosevic, S., Stanley, H.E.: Barkhausen noise: Elementary signals, power laws and scaling relations. Phys. Rev. E 54, 32531 1996CrossRefGoogle ScholarPubMed
7.Sipahi, L.B.: Overview of applications of micromagnetic Barkhausen emissions as noninvasive material characterization technique. J. Appl. Phys. 75, 106978 1994CrossRefGoogle Scholar
8.Juhász, R., Szabó, S., Kátai, Z., Bakos, F., Beke, D.L.: Nanocrystalline soft magnetic cores in applications. Mater. Sci. Forum 473-474, 459 2005CrossRefGoogle Scholar
9.Szabó, S., Juhász, R., Pogány, L., Daróczi, L., Beke, D.L.: Excellent magnetic properties, domain and atomic structure of specially heat treated Finemet type materials. Mater. Sci. Forum 473-474, 477 2007Google Scholar
10.McHenry, M.E., Laughlin, D.E.: Nano-scale materials development for future magnetic applications. Acta Mater. 48, 223 2000CrossRefGoogle Scholar
11.Chikazumi, S.: Physics of Magnetism 1st ed.John Wiley and Sons, Inc. New York, London, Sidney 1964 327Google Scholar
12.Daróczi, L., Balogh, Z., Erdélyi, Z., Beke, D.L.: Experimental setup for measurement of Barkhausen noise distributions. Act. Univ. Deb. Phys. Chim. XXXVIII-XXXIX, 91 2005Google Scholar
13.Kronmüller, H., Schäfer, R., Schroeder, G.: Investigation of the domain structure of amorphous Fe40Ni40P14B6-alloys. J. Magn. Magn. Mater. 6, 61 1977CrossRefGoogle Scholar
14.Schrefl, T., Fidler, J.: Modelling of exchange-spring permanent magnets. J. Magn. Magn. Mater. 177-181, 970 1998CrossRefGoogle Scholar
15.Bertotti, G.: Hysteresis in Magnetism Academic Press, Inc. San Diego 1998 156162Google Scholar
16.Pashley, R.I.: Barkhausen effect—An indication of stress. Mater. Eval. 28, 7157 1970Google Scholar